|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very pleased with the quality of the scan. No complaints whatsoever.
 ;
I liked the product. I would use their sevices again.
;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
BassPro II
INSTALLING THE REMOTE
The Subwoofer Level Control may be mounted under the dash or dismantled and mounted in the dash for a factoryinstalled appearance. UNDER-DASH MOUNTING Select a mounting location that allows easy access to the control while driving. Using the Subwoofer Level Control as a template, mark and drill holes in the mounting surface. Attach the Subwoofer Level Control using the mounting screws provided (Figure 4). IN-DASH MOUNTING Disassemble the Subwoofer Level Control by removing the two Phillipshead screws on the front panel, rear panel and on top. Remove the Subwoofer Level Control�s bottom and side panels. Slide the Subwoofer Level Control�s PC board forward to release the RJ11 connector from the back panel and remove the board along with the potentiometer, knob and connector as a single assembly. Choose a mounting location that allows easy access to the control, and provides 1-3/4" clearance behind the mounting surface. Drill a 9/32" hole in the mounting surface. Feed the Subwoofer Level Control�s potentiometer shaft (with the knob removed) through the hole and use the nut and washer provided to hold the control in place (Figure 5).
CONNECTING THE SUBWOOFER LEVEL CONTROL TO BASSPRO II
Route the cable behind the dash or other interior panels and under the carpet. Do not route the cable outside the vehicle. Connect the RJ11 cable between the RJ11 receptacle on the BassPro II and the receptacle on the Subwoofer Level Control (Figure 6). BassPro II Connection Panel
Control Cable
Socket Socket for for Control Control Cable Cable
Rear View of Level-Control Circuit Board Figure 6. Subwoofer Level Control electrical connection.
Washer Washer HexNut Hex Nut
Knob Knob
Level LevelControl Control Circuit Circuit Board Board
Figure 5. In-dash mounting of the Subwoofer Level Control.
Figure 4. Under-dash mounting of the Subwoofer Level Control.
7
|
|
|
> |
|
|
Parse Time: 0.229 - Number of Queries: 104 - Query Time: 0.043
